 |
I only needed two for my idler pulleys on my zero turn mower. I bought the TEN pack for less than what two would have cost me at a local bearing shop. I thought a few extra would be a good idea. They went in just like any other bearing and the noise level went down so much that I forgot to put on ear protection until my wife came out and mentioned it. She even said the noise level went way down. I mow over two acres and have mowed four times since installing these bearings and the noise level is still way down. ALSO I noticed the belts don't jump around as much with these new bearings. If you have a zero turn mower and you think it is loud it more than likely is the idler bearings and not the spindle bearings. These bearing are GREAT. and by the way these bearings are the ones with rubber seals on BOTH sides and keeps the dirt and sand out. Read full review
Verified purchase: Yes | Condition: New
Pool pump had a bad bearing. Trust me you will know when its bad! Disassembled the motor and took the number from the bearing. Order these as replacements, you need 2, one for each end of the motor shaft. Since you have the motor apart might as well replace both! Direct replacement for the original. Should last another 10 years!
Verified purchase: Yes | Condition: New
This is a good solid bearing, the numbers match the ones I took out so I took a chance that they would fit and they did perfectly. Went onto a Poulan lawn mower deck but i'm sure they have many other applications.
Verified purchase: Yes | Condition: New
This bearing is the exact size required for pulleys on Ford Escape. The smaller pulleys are usually sold with a bearing for $15 or more. The larger pulley is sold as an assembly for $100 plus or minus. This bearing, a concrete floor, the right size socket and a hammer...voila! Saved $380 quoted by mechanic for the larger assembly plus labor!
Verified purchase: Yes | Condition: New
I was reviewing cost of a new tensioner pulley for my suburban an this was an super easy replacement item that took a few minutes to do an was a fraction of the cost to replace the entire tensioner.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Other Bearing & Bushing Parts
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Other Bearing & Bushing Parts
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
